Metamphetaminum synthesis
At Metamphetaminum are used: an ephedrine, scarlet phosphorus and crystalline iodine:
1. An ephedrine, and also a pseudoephedrine is applicable for screw manufacturing. It represents one of ephedrine optical isomerides. Differences between a pseudoephedrine and an ephedrine any – the finished product from them is received the identical. From the medical point of view the pseudoephedrine reacts on the central excitatory system less awakely, conserving thus strong properties a l-isomeasure.
2. Scarlet phosphorus. Extraction (reception) of scarlet phosphorus from match boxes:
Contents of an incendiary coating on matchboxes:
1. P (scarlet phosphorus).
2. Sb2S3 (antimonies (III)).
3. Fe2O3 (iron oxide (III), a crocus).
4. SiO2 (silicon).
5. Glue.
Attention: do not feel sorry some muriatic acid on purification of phosphorus and time for the decanting, differently all these metals and sulphur, at interaction with HI and HCl will pass in solution!
Process:
1. 5 boxes of matches are bought. Then in the radio goods it is bought muriatic acid jar (36 %-38 %).
2. Using an edge we tear off “graters” from boxes as it is possible with a smaller layer of a paper, we put them on a plate (without drawings and a gold border) and we fill in with acid.
3. We put a plate on the water bath (the bowl/pan in which boils water on small fire – thus water in a bowl boils also a fallow heat ups a plate).
4. Acid becomes dirty colour and in it the different dust floats. Attention: it is not necessary to climb the person in a plate – pairs HCI unpleasant enough thing. In some minutes of “grater” become red on the one hand, and black from outside where there was a paper. We seize this moment and accurately we merge acid.
5. We flush water, then we flush acid. After that once again we fill in with new ration of acid and we put on a table for 5 minutes. We merge acid and again we wash with water. We put, that remains from graters (darkly red laminas), on glass, we triturate an edge and we wash off the rests of a mud by means of an injector with water. From 5 boxes 350 mg of phosphorus should be received. In any case, phosphorus received will comprise a certain besatz figure therefore at a backfilling in the reactor it is recommended to take such phosphorus, in calculation on mass, on 50 % it is more than pure scarlet phosphorus.
3. Crystalline iodine. Extraction (reception) of crystalline iodine from alcohol (pharmaceutical) solution of iodine:
1. We take 20 ml an injector, we seal off the terminal. In the piston some holes are done, we wrap the piston a scrap of a dense tissue the combined 2 times.
2. We fill in 17 ml of iodine in an injector, we add 2 ml of water, we drip 12 drops of muriatic acid. Slightly we shake and we put to settle.
3. After upholding in an injector almost transparent layer from above (in the absence of a layer we will add 1 more ml of water and 5 drops of muriatic acid) should be visible.
4. We insert the piston with a rag and it is pressed (to clean all fluid and to abandon only iodine crystals). That passes through holes in the piston it is poured out. In the end it is necessary to press strongly, trying to clean all moisture. Further the piston is taken accurately out. We take the newspaper, we invert an injector, we knock on it from above – almost dry iodine gets enough sleep. If there was a moisture we turn iodine in the newspaper and is extruded it.